This is where your grip on the pot call and striker will adjust as you get a better feel for how the two work in concert. Once you have the grip in a fairly comfortable position, it’s time to start learning how to do the four basic calls: yelps, clucks, purrs, and cutts. If you’re just not getting results, sometimes all it comes down to is how you’re holding the pot call and striker. You’ll probably find that your grip will adjust as you get better, and that’s okay. Practice your grip so that you’re automatically holding the pot and striker the same way every time, with the same anchor point. You’ll also be putting different amounts of pressure on the striker, so make sure you have a good range of movement and aren’t just pinned down to one spot on the slate. You want the tip of the striker to be at a 45-degree angle to the slate surface, but able to rotate up to 90-degree for certain calls. This will allow you more control and consistency. It’s important to anchor your striker hand resting on part of the hand holding the turkey call. ![]() Either way, working on your fundamentals is the first step. It’s what works best for you, your hands, and getting the best sounds. Some people work from the top of the pot call and some from the bottom, although most instructions you’ll see will only show it at the top of the slate. You’ll be working from the outside edge of the slate surface. Hold the striker like you would hold a pencil, about an inch up from the tip. Don’t let your fingertips touch the slate, or you’ll have to recondition it (more on that below). The tips of your fingers should be just slightly protruding above the top of the rim. Keep the bottom of the call off of your palm so the sounds can properly resonate with the body of the pot call. You don’t need all five fingers either, some callers only use their thumb and middle finger. Hold the pot in your non-dominant hand loosely, you don’t need to white-knuckle it. Learning a proper and comfortable grip that you can practice and get with consistency is key. These are the first things to get down when you’re learning how to use a slate turkey call. The best slate turkey call results are gained by learning how to properly hold the two elements: the pot call and the striker. How do you use a slate call for beginners? ![]() To get started, I went with the Primos Hunting Turkey Caller Starter Pack because it includes a pot call, mouth call, and box call. ![]() Turkey box calls are also simple and pretty easy to get the hang of, and mouth calls are by far the most difficult to master. Pot calls are also called slate calls, even if the material is glass or aluminum, and those are what we’ll be focusing on today. There are 3 basic kinds of turkey calls on the market: mouth calls, box calls, and pot calls. Bringing them in close is what this article’s all about, so if you want to get started, read on! Game calls will help you get them in range of your turkey decoys and get them curious enough to wander in and see what’s going on. Want to learn more about shotgun chokes? Check out our Choke Tube Guides to read more on the subject. No matter what kind of load you’re using, you’ll get the best patterns with Turkey Choke Tubes that are specialized for the job. 410 bore up to a 10-gauge shotgun, and if you don’t have specialized turkey loads, then regular old birdshot shotshells will work fine as long as you bring them in close and go for the headshot. Many places also have a fall turkey season, but when most of us think turkey hunting, we’re thinking spring. It’s also a great way to introduce young turkey hunters and beginners into the wide world of hunting traditions. Spring turkey hunting is a lot of fun, shaking off those winter blues and getting back into the field.
0 Comments
Leave a Reply. |